I am sometimes seeing lag when I go from scene to scene. I use the Donner transmitter with 7 receivers. It just recently starting having problems but it's intermittent. When the problem occurs, sometimes it will take seconds for lights to change.
Any ideas?
Thanks!
Wireless DMX Lag
Re: Wireless DMX Lag
I also use DMXIS with Donner receiver/transmitters. Lag happens when the receivers aren't getting a good signal from the transmitter. Try to reposition the transmitter to see what happens... also try moving the transmitter antenna around. It might have a bad connection.
I'm not sure of your setup, but you could also try adding a DMX terminator at the end of the line to improve the signal to noise ratio.
Edit: The wireless DMX system operates at 2.4 GHz. Other 2.4 GHz can sometimes cause interference. Check to see if any band members have started using a digital wireless system or if a router is nearby. If that's the case, take a look at the receiver's blinking LED. If it blinks slowly or intermittently when the other wireless source has been turned on, then that is the culprit.
I'm not sure of your setup, but you could also try adding a DMX terminator at the end of the line to improve the signal to noise ratio.
Edit: The wireless DMX system operates at 2.4 GHz. Other 2.4 GHz can sometimes cause interference. Check to see if any band members have started using a digital wireless system or if a router is nearby. If that's the case, take a look at the receiver's blinking LED. If it blinks slowly or intermittently when the other wireless source has been turned on, then that is the culprit.