My DMXIS software is behaving oddly.
I have 4 channel LEDs. RGB/UV. When I push up a channel fader, sometimes the corresponding color will light up...sometimes not. When I click on the channel again, the fader will jump to 0.
Usually, when I double click on, say, Red for one of my fixtures, all the RED channels on the same type of fixture will highlight so I can control all of them at once. This isn't happening anymore. I'm not sure what happened or what I did.
I tried to "reset all fixtures" and add them again but that didn't resolve the issue.
Can anyone help?
Channels reset when clicked
-
- Posts: 16
- Joined: Thu Jul 27, 2017 4:37 am
Re: Channels reset when clicked
Also ... on unassigned channels, when I move the fader up, the value stays at 0 even though the fader is all the way up. When I release my mouse, the fader goes back to the bottom.
-
- Posts: 2131
- Joined: Sat Sep 15, 2012 4:53 pm
- Has thanked: 6 times
- Been thanked: 18 times
Re: Channels reset when clicked
What version of DMXIS are you running? Mac or Windows?
Do you have a valid Input device selected in Preferences > Audio/MIDI Settings?
Do you have a valid Input device selected in Preferences > Audio/MIDI Settings?
Dave Brown - db audioware
Author of Show Buddy Setlist | Show Buddy Active | ArtNetMon
Author of Show Buddy Setlist | Show Buddy Active | ArtNetMon
-
- Posts: 16
- Joined: Thu Jul 27, 2017 4:37 am
Re: Channels reset when clicked
1.7.4
Yes, I have an input audio device.
FWIW, I enabled OSC in the preferences and that seemed to help a bit ... but for whatever reason, there are some channels in my fixtures that still don't change value when I drag the fader up/down. The value stays at 0.
Yes, I have an input audio device.
FWIW, I enabled OSC in the preferences and that seemed to help a bit ... but for whatever reason, there are some channels in my fixtures that still don't change value when I drag the fader up/down. The value stays at 0.
-
- Posts: 16
- Joined: Thu Jul 27, 2017 4:37 am
Re: Channels reset when clicked
I take that back ... the channel values are still staying at 0 when I drag a fader up.