Flash button
Re: Flash button
+1
We have this with the footswitch in DMXIS. It has the ability to "Load Last Preset (When Held)". When the switch is released DMXIS goes back to the preset it had been on.
It would be nice to extend this functionality to load any specific preset (not just the last one in the list of presets) when getting a specific Note ON command, then return to the preset when the Note turns OFF.
I would use this for Blinders, Specific Spotlights, Strobes, etc...
We have this with the footswitch in DMXIS. It has the ability to "Load Last Preset (When Held)". When the switch is released DMXIS goes back to the preset it had been on.
It would be nice to extend this functionality to load any specific preset (not just the last one in the list of presets) when getting a specific Note ON command, then return to the preset when the Note turns OFF.
I would use this for Blinders, Specific Spotlights, Strobes, etc...
-
- Posts: 22
- Joined: Tue Dec 18, 2018 11:07 pm
-
- Posts: 30
- Joined: Wed Nov 07, 2018 7:20 pm
Re: Flash button
How do you do that? I can't seem to figure it out in Show Buddy Active. I don't see the option for "Load Last Preset (When Held)" like it used to have in DMXIS.
Re: Flash button
Look under Universes | Send to USB Box | Footswitch | Click & holdStudio-412 wrote: ↑Fri May 24, 2019 4:00 pm How do you do that? I can't seem to figure it out in Show Buddy Active. I don't see the option for "Load Last Preset (When Held)" like it used to have in DMXIS.
Re: Flash button
+1We have this with the footswitch in DMXIS. It has the ability to "Load Last Preset (When Held)". When the switch is released DMXIS goes back to the preset it had been on.
It would be nice to extend this functionality to load any specific preset (not just the last one in the list of presets) when getting a specific Note ON command, then return to the preset when the Note turns OFF.
I would use this for Blinders, Specific Spotlights, Strobes, etc...
Re: Flash button
As an extension to this, how about each performance button can have two "modes". First is as now - click the button and you get that preset. If button is set to "mode 2" (or "flash" or "instantaneous") it selects that preset only while held. When released, the settings revert to previous?
Re: Flash button
How about just a one-shot ADSR (Attack Decay Sustain Release). Essentially a single shot OSC that runs just once when activated. With this you could create a ramp down, ramp up, momentary on/off, etc, etc.
This could even be a playlist of states that can be triggered by a single preset. A lot of the other software does this. It's essential in my opinion.
This could even be a playlist of states that can be triggered by a single preset. A lot of the other software does this. It's essential in my opinion.