Hey all,
I'm trying to program a Saw Down function for lights that start on beats 2 and 4, ONLY. I know you can set the timing on the bottom to be 1 bar, 1/2 bar, etc, but I'm looking to only have the function happen on beats 2 and 4.
I tried putting just the midi notes to cue this preset on 2 and 4, but it always repeats on 3 and 1. I also tried making a "blank" preset where it's dark to put in between, but then the Saw Down fade is very fast and unnatural (ideally I'd like it to extend for two counts instead of one)
The only way around this I can think of is cutting the tempo in my DAW by a fourth, but that seems excessive. Any ideas? Thanks in advance!!
Saw Down not on downbeat? Is this possible?
-
- Posts: 5
- Joined: Sun Apr 07, 2019 12:32 am
-
- Posts: 2123
- Joined: Sat Sep 15, 2012 4:53 pm
- Has thanked: 5 times
- Been thanked: 17 times
Re: Saw Down not on downbeat? Is this possible?
You can change the start point of the waveform using the Chase knob.
In your case, just select each channel with the sawtooth oscillator, and set Chase to 50%.
In your case, just select each channel with the sawtooth oscillator, and set Chase to 50%.
Dave Brown - db audioware
Author of Show Buddy Setlist | Show Buddy Active | ArtNetMon
Author of Show Buddy Setlist | Show Buddy Active | ArtNetMon
-
- Posts: 1
- Joined: Mon Oct 23, 2017 2:54 am
Re: Saw Down not on downbeat? Is this possible?
Is there a quick way to set all 512 channels on a preset to a Chase value? For instance, if I wanted to set all 512 of the faders' Chase value to 50% (without having them chase together), could I do that with just a few clicks? This article and this article are both related to this Oscillator timing issue.Dave Brown [admin] wrote: ↑Sun Apr 07, 2019 12:27 pm You can change the start point of the waveform using the Chase knob.
In your case, just select each channel with the sawtooth oscillator, and set Chase to 50%.