Saw Down not on downbeat? Is this possible?

Anything & everything relating to ENTTEC DMXIS.
Post Reply
Posts: 5
Joined: Sun Apr 07, 2019 12:32 am

Saw Down not on downbeat? Is this possible?

Post by GrayDeWolfe » Sun Apr 07, 2019 12:38 am

Hey all,

I'm trying to program a Saw Down function for lights that start on beats 2 and 4, ONLY. I know you can set the timing on the bottom to be 1 bar, 1/2 bar, etc, but I'm looking to only have the function happen on beats 2 and 4.

I tried putting just the midi notes to cue this preset on 2 and 4, but it always repeats on 3 and 1. I also tried making a "blank" preset where it's dark to put in between, but then the Saw Down fade is very fast and unnatural (ideally I'd like it to extend for two counts instead of one)

The only way around this I can think of is cutting the tempo in my DAW by a fourth, but that seems excessive. Any ideas? Thanks in advance!!

Dave Brown [admin]
Posts: 1818
Joined: Sat Sep 15, 2012 4:53 pm

Re: Saw Down not on downbeat? Is this possible?

Post by Dave Brown [admin] » Sun Apr 07, 2019 12:27 pm

You can change the start point of the waveform using the Chase knob.

In your case, just select each channel with the sawtooth oscillator, and set Chase to 50%.
Dave Brown - db audioware
Author of DMXIS | D-Pro | Show Buddy | Show Buddy Active | ArtNetMon

Post Reply