Hello!
Was wondering if its possible with D-Pro to control and receive feedback via OSC for individual dmx channels like what is documented for Showbuddy Active?
Command
/dmxis/ch/x [level]
x = DMXIS channel number (1-512)
[level] = float representing the
channel level (0.0-1.0)
TX & RX
Description
Sets a single DMX channel fader to the
specified level.
I'm trying to achieve "motorized faders" effect from D-Pro to TouchOSC.
OSC Direct control over single fader?
-
- Posts: 2131
- Joined: Sat Sep 15, 2012 4:53 pm
- Has thanked: 6 times
- Been thanked: 18 times
Re: OSC Direct control over single fader?
OSC in D-Pro lets you manipulate the Show Control window. You cannot access individual DMX channels directly via OSC (as you can in Show Buddy Active)
In D-Pro, first create some simple cues which set the required channels to 100%. For example, here's a cue that sets a single dimmer on channel 1 to 100%...
Then drag those cues onto Show Control sliders, and activate the "Override" flag...
Then use the following OSC command to control the cue...
In D-Pro, first create some simple cues which set the required channels to 100%. For example, here's a cue that sets a single dimmer on channel 1 to 100%...
Then drag those cues onto Show Control sliders, and activate the "Override" flag...
Then use the following OSC command to control the cue...
Dave Brown - db audioware
Author of Show Buddy Setlist | Show Buddy Active | ArtNetMon
Author of Show Buddy Setlist | Show Buddy Active | ArtNetMon
-
- Posts: 22
- Joined: Wed May 18, 2016 4:38 am